Risco-group GT490X Bedienungsanleitung PDF herunterladen (Seite 17)

Keypad

Opening (default = Always On)

This controls the keypad option during Entry/Alarm, and controls whether the

keypad will lock-out during entry or in an alarm condition. The option is used for

BS8243 systems using G-Tag and the keypads need to lock-out in certain

circumstances. Settings available are:

Always On Keypads will always be accessible

Off in Entry Keypads will be locked-out during Entry period

Off in Ent/Alm Keypads will be locked-out during Entry period or during

alarm

Default = Always On

ET (Exit Terminator) Mode (default = Set)

If ET Mode = Set then the exit terminator zone will terminate the exit procedure.

If ET Mode = Door Lock and the ET zone (door lock) is operated on entry then all

confirmed alarms will be disabled.

Bell Mode (default = Unconfirmed)

This option controls the bells fitted to the system, options are confirmed or un-

confirmed.

If Bell Trigger = Confirmed then Bell will only trigger with a confirmed alarm.

If Bell Trigger = Unconfirmed then Bell will trigger with un-confirmed alarms.

This feature is not mandatory for BS8243

Strobe Mode (default = Unconfirmed)

This option controls the Strobe(s) fitted to the system, options are confirmed or un-

confirmed.

If Strobe Trigger = Confirmed then Strobe will only trigger with a confirmed alarm.

If Strobe Trigger = Unconfirmed then Strobe will trigger with un-confirmed alarms.

This gives the ability to show to the keyholder from outside the premises that a

previously unconfirmed alarm has is now confirmed.

This feature is not mandatory for BS8243

Confirmed Start Delay (default = 000m)

May be programmed between 0 & 120 minutes (default 0).

If programmed to anything other than 0 the panel cannot send confirmed signals

until the time programmed has expired. This time starts when the system has set

and will prevent confirmed alarms being generated in situations when a person has

been accidentally locked in the building.

This feature is not mandatory for BS8243

Page 16

PR5846 Rev12 490X QS Eng.qxd 10/05/2012 11:39 Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Risco-group GT490X Bedienungsanleitung Seite 17