Risco-group GT490X Bedienungsanleitung PDF herunterladen (Seite 10)

Engineer Programming Mode

Engineer Programming

To enter the engineer programming mode follow the steps outlined below:-

1. Remove all power from the system for at least 10 seconds.

2. Apply mains power to the control panel. The display will show, for example:-

3. Whilst this display is showing (the first five

seconds) press for the reset required.

(E.g 4 6 Yes No).

The display will then show:-

This may show for several minutes.

The display will then show:-

The display may differ from the sample shown

Selecting 1:BS - Panel may be programmed to comply with the old BS4737

Standards. DD243 requirements will still apply.

Selecting 2:EN2 - Panel may be programmed to comply with EN50131-1 for Grade 2

Systems. BS8243 requirements will still apply.

4. Select 2:EN2.

Note: This document assumes that 2:EN2 has been selected. If 1:BS has been

chosen, please refer to GT490X Control Eng. Ref. Guide for further information.

Available from the GardTec web site.

The display will show:-

This may show for several minutes.

GT490X xx-xx

Please WAIT

Select Standard

1:BS 2:EN2

Please WAIT

Version

Page 9

PR5846 Rev12 490X QS Eng.qxd 10/05/2012 11:39 Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Risco-group GT490X Bedienungsanleitung Seite 10