Risco-group GT480 Bedienungsanleitung PDF herunterladen (Seite 22)

Resetting to F

actory Defaults

If required the unit may be reset to factory defaults. It should be noted that if the engineer

code begins with a 9 it will not be defaulted.

1) Remove all power from the system.

2) Wait 10 seconds.

3) Re-Apply power to the system.

4) As soon as the display becomes active enter 1 4 7 No ( ).

Log Mode

The log may store 256 events with time and date stamp and cannot be changed (EN only).

Note: If programming a non EN control panel, the Log modes may be changed.

Please follow the steps outlined below.

Changing Log Modes (Non EN Panels)

a) 256 events without Time & Date stamps

b) 64 events with Time & Date stamps (Default setting)

To change the Log Mode:-

1) Remove all power from the system.

2) Wait 10 seconds.

3) Re-Apply power to the system.

4) As soon as the display becomes active enter 0 0 7 No ( ). For 256 events.

As soon as the display becomes active enter 9 1 7 No ( ). For 64 events.

Note: When the Log Mode is changed the message ‘ L/ Rst ‘ will be added to the

Log

GardTec 480 ENG PR5832 Rev 115IN480IM B A5booklet.qxd 18/07/2007 20:35 Page 19

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Risco-group GT480 Bedienungsanleitung Seite 22