Risco-group GT480 Bedienungsanleitung PDF herunterladen (Seite 17)

29) Press No ( ) until the required Part Set Exit Mode is

displayed. Then press Yes ( ). The display will show:-

30) Press No ( ) until the required Part Set Sounder Mode

is displayed. Then press Yes ( ). The display will show:-

31) The Confirm Mode relates to strobe confirmation.

Press No ( )until the required setting is displayed. Then

press Yes ( ). The display will show:-

Note: The Quick-Set is no longer applicable on the

GT480 Control Panel

32) Press Yes ( ). The display will show:-

(Default 30 seconds)

33) Default Entry Time 1 is 30 seconds. To change, press

No ( ) followed by the time required.

Then press Yes ( ). The display will show:-

34) Default Entry Time 2 is 10 seconds. To change, press

No ( ) followed by the time required.

Then press Yes ( ). The display will show:-

Note: Entry procedure is; Open entry door, entry time 1 starts. Entry time 1 runs to

the programmed time or until there is a deviation from the entry route. Then Entry

Time 2 starts, at the end of Entry Time 1 the bells will be activated.

35) Press 0 to escape back one level. Then press No ( )

to go to the next Header. The display will show:-

Press 0 three times to escape out of Engineer Mode.

Program . . . . . . .

Bell & Panic ?

F - Exit Time

Entry 1 Time

Entry 2 Time

Confirm Mode

Off

P - Exit Sounder

Aud.

Quick-Set

Off

GardTec 480 ENG PR5832 Rev 115IN480IM B A5booklet.qxd 18/07/2007 20:35 Page 14

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Keine Kommentare

Risco-group GT480 Bedienungsanleitung Seite 17